How To Prepare Rough Plaster Or Drywall For Wallpaper
Posted: Wednesday, August 23, 2006
by Edwin Brown
http://www.plaster-wall-ceiling-solutions.com
You've decided to wallpaper those walls, but what to do about that rough texture?
In my experience, you have two basic choices. You can put a liner on the wall first (provided the texture is not TOO rough). This mutes the texture and provides a smooth (relatively) surface to glue paper to.
If you are using the services of a professional paperhanger, you will be paying for the liner and the hanger's time to put it on. On top of the price to hang the paper itself. And a paper with a delicate pattern may still show some of the irregularity.
This is do-able, if you have time and patience.
The first thing to do if you choose this option is to prep the surface. Remove any scaling paint, powder, dirt, etc. If you have any water stains, I would seal them by brushing on a stainkiller, preferably oil based.
If you wash down the walls, clean rinse after to remove any soap or cleanser residues.
I usually go over the surface with a study flat tool to knock off the worst of the rough points, if possible. This may help to reduce the number of coats of mud required.
Now you are ready to go. Know that you will have to apply a minimum of two successive coats of all-purpose compound, or more if the texture is pretty rough.
Tools: a ten or twelve inch broadknife and a mud pan. Or, a plasterer's hawk and trowel.
There is a proper order to skimcoating, to ease your job as much as possible.
The key here is to make your strokes all go in the same direction as you do each coat.
If you chose to go horizontally first, start up in the corner near the ceiling and work your way across the wall and down.
After that coat dries, start at the top again and go the other direction this time.
Third coat if necessary, repeat what you did when you went vertically.
At this point, you may get by with a good sanding to smooth out tool marks. If not, do another coat, varying your stroke directions according to your judgement of what works best. The final step is sanding. Medium grit sanding sponges work well here.
There is another way to do this that may be easier. Lay down your mud in parallel strips. When they dry, fill in the gaps. You could choose to do each coat that way. It will take more days to complete the job this way.
Now that you finally have a smooth surface you can live with, be sure to put a couple of good coats of drywall primer/sealer (PVA) to render the porous surface fit for wallpaper.
You did it! Now that wasn't too bad, was it?
______________________
For more complete information on skim coat procedures and issues, you can access my skim coat page at http://www.plaster-wall-ceiling-solutions.com/skim-coat.html
This Article has been viewed 1,733 times. (Not updated in real-time.)
No comments yet.We want your comments! If you can read this, you don't have javascript enabled, so you can't use this comment system. Please enable javascript.